MCU FT232H převodník USB na UART, JTAG, SPI, I2C

MCU FT232H převodník USB na UART, JTAG, SPI, I2C

Feature:

• Single channel USB to serial / parallel ports with a variety of configurations.
• Entire USB protocol handled on the chip. No USB specific firmware programming required.
• USB 2.0 Hi-Speed (480Mbits/Second) and Full Speed (12Mbits/Second) compatible.
• Multi-Protocol Synchronous Serial Engine (MPSSE) to simplify synchronous serial protocol (USB to JTAG, I2C, SPI (MASTER) or bit-bang) design.
• UART transfer data rate up to 12Mbaud. (RS232 Data Rate limited by external level shifter).
• USB to asynchronous 245 FIFO mode for transfer data rate up to 8 Mbyte/Sec.
• UB to synchronous 245 parallel FIFO mode for transfers upto 40 Mbytes/Sec
• Supports a proprietary half duplex FT1248 interface with a configurable width, bi-directional data bus (1, 2, 4 or 8 bits wide).
• CPU-style FIFO interface mode simplifies CPU interface design.
• Fast serial interface option.
• FTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.
• Adjustable receive buffer timeout.

Applications:

• Single chip USB to UART (RS232, RS422 or RS485)

• USB to FIFO

• USB to FT1248

• USB to JTAG

• USB to SPI

• USB to I2C

• USB to Bit-Bang

• USB to Fast Serial Interface

• USB to CPU target interface (as memory)

FT232H datasheet:  https://www.ftdichip.com/Products/ICs/FT232H.htm